Interested to Buy Any Domain ? << Click Here >> for more details...
if only one generator is running in droop mode parrallel
with grid and suddenly grid breaker off what will happen?
It will trip o/u freq or stay as it is? (urgent)
- 10 Answers
- 15227 Views
- I also Faced
- E-Mail Answers
Answer Posted / kintoko adji
It's all depend on load and generator capacity, if load is
greater than generator capacity. If the load is much
greather than generator capacity (exam : 2 times of gen
capacity, it may trip because of under frequency, but
usually overload will be trip the generator CB first), but
if gen capacity is bigger than load, it will stay as it is.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
Why we are using Isolation Power Transformer inplace of commercial power transformer? What's the difference between them?
What is the function of NER and NET?
how to compute kvar in substation feeder to improve power factor and sending voltage
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
for 5KW resistive load can anyone please suggest me whether to go for UPS/Inverter or Generator depending upon cost calulations
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
What are high pass filter and low pass filter? and What are the flowmeter ?
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
What is self exciting?
Which type of DG need Netral Earthing?
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
Why compensation is necessary in feedback control system?
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
