Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / anand
actually when we provide the ac supply to the primary
winding then aflux gets induced in the core,this flux
complets the path through the core because ac current is
varying type so the flux induced will also be of varying
type ,so this induced flux causes a current induced in the
secondary winding.and this case is not with dc current.So
only ac current is used in the transformer.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
what & how to check the lightning arrester
What cmos is and its benefits?
How many kinds of E.L.C.B and how to work E.L.C.B
Can clean earth cable be considered as low current cable
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
what is the relative size of single and three phase?
What are the ratings of VCB, MCB, MCCB, SF6, ACB, and OCB?
PLZ EXPLIN ABOUT CLASS PS CLASS CT .WHY THEY R DESINED AND FOR WHAT PURPOSE?WHY OTHER CT CANT BE USED AS PS CLASS CT? EXPLAIN IN SIMPLE LAUNGAGE IF POSSIBLE PLZ GIVE CIRCIT DIAGRAM?EMAIL-RAJ_SINGH_0376@SIFY.COM
State superposition theorem?
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
ROC converges if pole and zero lies inside a) origin b) z=1 c) pole d) zero ? Explanation please? if ROC does not converges then?
A motor running with lenze frequiency inverter stops if I REDUCE SPEED with 25% load.If I run it in High speed and medium speed running smoothly with full load.please help me to solve it.
11 kg trivevter meter has rating of -/5amps. And pt ratio11000/110v and is connected with 11kv ct/pt unit of cr ratio 75/5amps. And pt ratio of 11000/110v while checking accuracy of meter with HT Accuchek meter what value of PT ratio and CT ratio to be filled in Accuchek meter
