Interested to Buy Any Domain ? << Click Here >> for more details...
what is the effect of power factor in electrical circuit ?
if we mainten power factor near about unity (0.999) our
energy consumption Units increase or decrease?
- 11 Answers
- 16379 Views
- Piramal Healthcare, I also Faced
- E-Mail Answers
Answer Posted / yogesh
As we know Load is in KW & it is constant. PF will not
change units consumed as we are measuring energy consumption
units in KW not in KVA, only transmission losses will be
reduced.
KW=1.73 X V X I X cos phi
AS KW is constant, voltage is constant if cos phi changes
current will be changed.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
what is submersible pump?what is different between motor and sub motor?
Block diagram of Power line communication?
how to calculate the fault in substation
What is gross error?
primery try cell?
what is the principle of the single phase energy meter? and,what is the advantages and disadvantages of single phase energy meter?
Can we Co-ordinate relay in Load Break switch?
Basic motor transformer generator
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What are the types of windings present in the ceiling fan? What winding will be effective first when we started the fan?What are the resistance and inductance ratios comparatively at the initial speed and full speed of the fan?
i have been tasked with a design of protection, metering and control(PMC) relay panel extension to accommodate all PMC relays.There is an already existing panel where this one will be built.What are the design aspects for this kind of project? thank you.
how to calculate cable size in diffrent loads?
what is the practical application of full adder circuit?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
