1. Why transfomer reting in KVA and Motor in HP
Answer Posted / b
because of it properties
| Is This Answer Correct ? | 1 Yes | 23 No |
Post New Answer View All Answers
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
what is mean by kneepoint voltage? when it will happen? ( my doubt is, if CT secondary is open means ct get saturation or blas? what are factors are required for calculations? plz give currect anws:
what will happen if OLR CT in all phases are short circuted
Is there any problem about which the drive (inverter) doesn't show/display the alarm and/or fault but instead of this , it doesn't work ? I want to know that could there be any kind of problem in the drive when the drive doesn't display the alarm and/or fault ?
is it possible to test of bus bar in high rise building without completed full floor ?
how many safety really of DG sets.
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
Shall I use 40A semiconductor Fuses in 32 A SFU ? Frame size is same. What Happen if Fuses burn on SFU?
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
how withstand of hi-pot test outputs of transformer wire 2.5mm
why is using sensor?what is differece between photoelectric and proxmitty?
Please send 110 kv sb station full single line drawing(sld)
Can you explain about Restricited earth fault protection scheme
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?