Interested to Buy Any Domain ? << Click Here >> for more details...
WHY WE ARE EXPRESSING KW-HR AS UNIT OF
ELECTRICITY.........?WE CAN EXPRESS IN ANOTHER UNIT.....?
- 4 Answers
- 8124 Views
- Summit Power, I also Faced
- E-Mail Answers
Answer Posted / anil bhatia
the energy meter which measure unit is desine to calculate
kwh . ie 1000 X wattes x Hrs (time consumed or used the
power).
where watts is volts X current .
voltage= is applied/given volts,
current=Amper taken by load
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
i want to know that what is the eligibility critaria for ongc exam?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
Where is servomechanism used?
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
How does the phase sequence controller works, how it identifies the phases? confirm working principle
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
1.what is the reason for transformer and lightning arrester blast in 33kv system
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
Difference between earthing & grounding.?
what is the interrelation between voltage current torgue speed and magnetic flux in case of different types of electric motors
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
