Why most of analog o/p devices having o/p range 4 to 20 mA and
not 0 to 20 mA ?
- 2 Answers
- 5130 Views
- I also Faced
- E-Mail Answers
Answer Posted / abanikanta
Thank u Mr.EKailash .I think it is required answer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between dry and wet type of 132kV terminations. which one is durable
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
How to check the thermocouple is correctly connected to cable for K type? (i,e positive pole is connected to non magnetic conductor and negative pole is connected to magnetic conductor)
State thevenin’s theorem?
What is rotating magnetic field?Discuss elaborately.
If the earth is a good conductor of electricity, why don't people get shocked every time they walking on earth?
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
Why in ESP Positive earthed
sir, 3phase induction motor takes different pf and different KW in three phase while running,explain reason
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
