Interested to Buy Any Domain ? << Click Here >> for more details...
two bolbs of 100w and 40w respectively connected in series
across a 230v supply.which bolb will glow bright and why?
- 16 Answers
- 63692 Views
- DRDO, PSPCL, Siemens, I also Faced
- E-Mail Answers
Answer Posted / mithil
40W bulb will glow efficiently.
Because, Current in series connection is always same and
voltage is divided.
here, resistance of 40W bulb is higher than 100W bulb.
so current required to glow a 40W bulb is less than 100W
bulb(it is quite appeared from ratings).so current flowing
from the cicuit is according to the eq.resistance of both
bulb and that would not exceed that current,which can blow
off 40W bulb and less than current which fully glow the
100W bulb.remember formula I=V\R.
(note that bulb is purely resistive load)
| Is This Answer Correct ? | 109 Yes | 24 No |
Post New Answer View All Answers
when measure the core loss of three phase distribution transformer or three phase reactor loss, one phase shown negative watt loss. why??
I am applying for NTPC examination.Can we please provide previous paper to my mail prasad.chintala108340@gmail.com
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
What is domestic transformer? Draw the connection of domestic transformer.
What is pole of the system?
The electromagnetic torque developed is proportional to what in a D.C series motor?
What facility we get after CT secondary earthing and how?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
how generator load test is conducted?what are the steps?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
What is stacking factor? What is its approximate value?
How we can recongnise the phase displacement of transformer connection between primary & scondary...plzzz explain it with example.........
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
