Interested to Buy Any Domain ? << Click Here >> for more details...
We have 800KW motor operating at 6600Volt,50 Hz
supply.During 1st startup it tripped on overcurrent
trip.It's FLA is 88 Amps.The K factor of Thermal overloaaad
was set on .94 initially.then we set at 0.97 and then it
started fine.i dont understand why it tripped first?What
are the protections which comes in picture during starting ?
- 6 Answers
- 9559 Views
- I also Faced
- E-Mail Answers
Answer Posted / prabhukumar
we all know that the starting current of motor is 5 times
more than of rated current.
for the starting current also some settings will be their
in that the starting current time may be less and the
starting time the heat will be their.
You just check it out and tell me.
prabhu.jsw@gmail.com
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What happen to generator if i have unbalanced load?
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
Why compensation is necessary in feedback control system?
what is formula for calculate thermal overload in new numiricalrelay( not in bimetal relay)?
difine electrical ballast in HPSVL
block diagram of 2 ups system connected in hot stand by mode?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
How to dimensioning SDCCH, LAPD and CS7 signaling on GSM?
why burdens of VTs is more than CTs?
What are the essential characteristics of signal flow graphs?
how can we make cable shedule for controll wiring ? which details must be required for it.?
WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane
What is UPS and How do you maintain the UPS Maintenance? Brief Description on UPS maintenance.
what is the method of earthing of a transformer using electrodes?
what is the effect of back reactive power on the generator ?
