Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ankush miglani 09718151073
it is proportional integral derivative controller
it is basically used in industry controllers
there r three blocks one is p, then i and at last d
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
how will we calculate the copper wire load..
When a single pase capacitor run motor- run on 230vac and Case(1)run with 8 Mfd 250 vac.capacitor , Case( 2) run with 8 Mfd 400vac capacitor. What is difference between both case regarding power ,efficiency etc?
what is the minimum clearance between a 11KV 150KVAR capacitor cell and series reactor.can a series reactor can be mounted in the same structure of the capacitor cells structure
please send me the L&T Emb. sys. placement papers and entire details of pattren
What is the Good Earth resistance value of G.I & Cu. Chemical Earthing & Normal Pipe Earthing?
what is mean by parallel operation of permanent magnet generators
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
what is ramping rate of generator
How can I known multiplying factor .without multiplying table
At the starting of dc motor and syn.motor and induction motor high current flowing through the winding. Due to this the windings burnt out. To avoid this different types of starters are used. But incase of transformer what Will be used (At starting no emf is induced in the primary winding)?
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
Why are short circuit ratings always 16kA,25kA,36kA and 50kA.Who has fixed these?
hi friend i am going too attend for hpcl in this month please help me by sending written test question papers i am in the stream of E.E.E
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
Why is voltage is required to be within permissible range for an electrical equipment?
