Two electronic energy meters are connected to seperate
phase wires, but connected to a looped neutral. Are these
going to function correctly?
- 8 Answers
- 11288 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / raj varpe
yes as the required input is provided to both energy meters
they will work satisfactorily but they are not usable to
measure 3-phase power correctely
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
For electrical designers what are the standard should know? i want learn about this standards. how to get information/reference. anybody help in this regards please.
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
testing of Vector Group – YNaoD II
DESCRIBE THE CONSTRUCTION ANDOPERATION OF BELT CONVEYORS AND SCR CONVEYORS , DRAW NEAT SKETCHES
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
What is the normal phase difference between the voltage and the no-load current in a transformer?
Why Neutral Isolation is required?
state working of halogen lamp?
What is an Air COmpressor
I PURCHASED A DEISEL GENARATOR SET OF AVR TYPE& RATING 125KVA BUT SOME TIMES THE OUTPUT VOLTAGE IS FLUCTUATING WHAT ARE THE PROBABLE REASONS GIVE ME
We have studied about many techniques for finding the stability of system, ROOT LOCUS, ROUTH, BODE PLOT, POLER PLOT etc. In these which is used where. what are the difference among them... PLZ tell me.......
how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?
How seriving & testing of the HT & LT breakers are done. What are the standard Ir values on which we can come to know the test is passed or failed?
