Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT AC (HI VOLTAGE TEST) VOLTAGE SHOULD APPLY FOR 33KV
CABLES.EXPLAIN IN DETAIL
- 12 Answers
- 23350 Views
- NTPC, Voltech, I also Faced
- E-Mail Answers
Answer Posted / john sundararaj
First decide on which type of cable
type of insulation,single core or 3 core
Ans 8 is the right one.Always go by the manufacturers
recommendation.The values differs for each standards and varies for different countries/utilities.Most of them prefer
soak test rather than hipot.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How to calculate Air conditioning capacity for a telecom BTS shelter?
WHAT IS DIFFERENCE BETWEEN MANUAL CONTROL AND MAGNETIC CONTROL AND STATE ITS ADVANTAGE /DISADVANTAGE
Differentiate between low pass, high pass and band pass filter?
1)Explain why the cradle guard is used on railway crossing in overhead line construction?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
Can you any one explain application of buccholz relay operation and pressure relif device operation of power transformer
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
i had aplied Hindustan Petroleum corporation limited for the post of maintenance technician -Electrical,i want model questions,if anybody have please send it or please advice?
What are the main advantages of bode plot?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
during installation time of transformer and alternator which points we have to observed?
What is a system?
what is lumped and distributed elements?
