Interested to Buy Any Domain ? << Click Here >> for more details...
Does frequency change with increasing voltage i.e 220v to
11kv? explain if not?
- 6 Answers
- 11020 Views
- I also Faced
- E-Mail Answers
Answer Posted / jay
transformer is a static device which transfers energy by stepping up or stepping down voltage with constant frequency.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
If more than rated DC voltage appears across trip coil of the breaker, what will happen? e.g. in 110V DC circuit system, if voltage across battery terminal showing 121 V
Grid fault level [KA]?
why do we put a transformer on soak before loading it
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical
Does magnetomonopoles exists? one maxwell equation strongly suggests no, but how about their existance in plasma?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
What is the difference between Delta & Wye windings?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
What is the effect of pi controller on the system performance?
how to calculate the lightning arrester conductor @ no of earth pits required
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
In ACS 1000 drive we are using 12 pulse converter,why don't use 3 pulse converter.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
What is signal flow graph?
