How to take of Transformer oil Break down voltage test?
- 2 Answers
- 4857 Views
- I also Faced
- E-Mail Answers
Answer Posted / pillay
i assume your question is how to take transformer oil for
breakdown voltage test.
the sample is taken from the oil drain cork. the containers
and any other equipment used for this job must be ensured it
is dry and not contaminated or this contamination will
influence the oil test results.
1. The sample is connected from the drain cork through a
small hose to a syringe. the initial oil is not taken. from
the syringe the oil is transfered to a sample bottle slowly
without forming air bubbles or too much external atmospheric
contact.this oil is used to test for the dielectic breakdown
voltage in a special tester.the minimum breakdown voltage
depends on the operating systems voltage and local
regulations.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
An active element is one which a. Supplies energy b. Absorbs energy c. Supplies energy and convert energy from one form to another
What is relation between transmission lines & Communication lines ?
in science exhibition how lamp can blink when you clap near the lamp ? thank you
How cmd is calculated in case of energy neters
How can we convert 11 kv to 440 volt without using transformer ?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
what is the generator rating for 40 amp load of 3phase motor.?? 400v voltage of generator... plz tell me with formula its urgent...plzzz... and also tell me that this 40 amp at all phases mean 40 amp on red,40 amp on yellow,40 amp on blue...... or the total sum of that 3phase is 40 amp....
Hi, Next week Iam appearing RRB exam for section engineer. So help me to get modal question papers for this position. Iam very thankful to you. Whether question will be fully techanical format or general form. Please give me a details regarding this exam.
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
What will be the current if the resistance total in a series circuit doubles?
What is Long rod insulator and it's applications..? merits over the disc insulator ..?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
How to operate a ac chilar plant?
why we use 630mm single core cable for transformer secondary side and why two neutral cable
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
