Interested to Buy Any Domain ? << Click Here >> for more details...
why we use 0.2 to 1.0 kg/cm2 output in control valve
- 4 Answers
- 14598 Views
- GNFC, I also Faced
- E-Mail Answers
Answer Posted / s k
because the control valve work within the specified pressure
range of about 0.2 to 1.0 kg/cm2.
| Is This Answer Correct ? | 2 Yes | 8 No |
Post New Answer View All Answers
How to Calibrate Temperature Switch in field
you are on site,the plant trips,you are approached by operations,what do you do?
selection of the zener barrier for the hazardeous area zone 0
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
what is the difference between scaler and vector drive
how to work static pressure sensore how to work dpt
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
How does temperature bath work? How does coil gets heated only by applying some current?
how to calibrate steam control valve in steam turbine
Any one can help me to identified, how can we interchange the device in FF
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
how to calibrate 0- 150 psi presure gauge by dead weght tester
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
