how many methods for starting an induction motor?
Answer Posted / ankush miglani 09718151073
DOL DIRECT ON LINE STARTER
STAR DELTA STARTER
VARIABLE FREQUENCY DRIVES
RESISTANCE STARTERS
AUTO TRANSFORMER STARTER
SERIES REACTOR STARTER
| Is This Answer Correct ? | 35 Yes | 0 No |
Post New Answer View All Answers
1. what is usage for power factor in industries?? 2.why we need to monitor power factor??
why we use single core 630mm2 cable for transformer secondary side
Hoe do calculate the Cable size for Amps rating ?
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
diameter of cable and core is doubled then the value of capacitance is
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
What is the effect of pi controller on the system performance?
Why do we avoid electrical conduits in floors at apartments?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
WHat is the general checks required for Dry type transformers
If VFD is On but no starting commond on it. so how many outpout voltages of VFD
why you don not show protection and type of isolation in key single line diagram?
how can maintaince the acb contactor moveing and fixing kit
What is dielectric loss?