Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ch.phani
ac transmission is cheaper though the losses in this are
high compared to dc
because dc cannot be stepped up directly and so the the
inverters and rectifiers comes into picture which has to
deal the high powers (in the order of mw).asn so the cost
is high
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
1. If 8.35%Z means the percentage impedance of 132kV-line from power company, we will like to reconfirm its base capacity.
What is the rating of a circuit breaker needed for 300 kv load in 33KV supply line of 33/415 transformer ? Whether 800/1200 amp vaccum circuit breaker can perform for a 33 KV line in input in 415 volt in output of the transformer ?
In PFI plant one stage capacitor connection is directly connected(with out megnetic contact controll). but why?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
If we have 11 kv RYB Phase single core cable near about. Then wht effect and losses
What is the different types of cable & current capacity of cable
What is a advantage of Self Reset Lockout ? On Fault breaker get trip & fault no longer exist then self reset lockout how inform us?
What is class ab operation?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
How to calculate cable size in HT AND LT
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
What is meant by sag?
