how to convert transmitter milliamps output to like
temp,pressure etc.....
- 5 Answers
- 26172 Views
- I also Faced
- E-Mail Answers
Answer Posted / neeraj pundir
with the help of transducer we convert (temp,pressure) in
outputs milliamps signals.
| Is This Answer Correct ? | 5 Yes | 3 No |
Post New Answer View All Answers
all questions related to instrument technician in any offshore oil and gas company.
Somebody can explain me about >Critical Loops, calibrations, ESD critical Loop checks, Logic Diagram / Cause & Effect checks for ESD loops,
What is the use of each wire in three wire RTD
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
why we use 3 wire rtd direct wiring for temperature measurement instead of temperature transmitter like bearing temperature
pls provide me syllabus and old question paper of instrumentation engineering for GET(JSPL)
Give Detail information about plc,dcs,and scada system?
I am manjunath having exp in maintenance of chemical plants,know i want to do a design course INTOOLS,after doing design course can we get jobs in design field.sinve i dont have design exp..
why would you like to join our company
all types of liquid analyzer principle with drawing?
Give an example where you had aproblem on the job, and tell me how you solved the problem. and the finalvoutcome.
I have energy meter for educational project having 0.5s class but my friend need 0.2s class meter , which one is good for that purpose and what is the actual difference of that two classes , need very easy example also.??
when a magnet is heated?
What are the uses of orifice plates?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
