Interested to Buy Any Domain ? << Click Here >> for more details...
What r the specification furnishid in motor name plate?
- 5 Answers
- 8042 Views
- I also Faced
- E-Mail Answers
Answer Posted / zan
they are
1 typeof connection
2 capsity
3 RpM
4 phase
5 poles
7 if induction Excitation volatage
8 DC/AC
9 manufactures name
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is earth system using on the floater TN-S or TT. Iam not sure and what ICCP
what is ratio of copper wire size and current ?
how much GROUND & NEUTRAL VOLT maintain in data center.
what the principle of sincroscope?how it works?when it needed?
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
When semiconductor fuse does save thyristor in each cycle of conduction? Why under voltage setting keep less in SPRS and more in DC drive?
Can you used moeller lzm1 mccb in a dc system with 125vdc and 20ka short circuit current , beside is it have 24 or 48 volt shunt ? Beside how long current can through from An MCB shunt contacts? (like Z7-AS 24 V)?
What difference between ref protection and differential protection ?
What types of high speed CMOS circuits have you designed?
what is meant by neutral compensation factor and where it is used
Role of active and reactive Power sharing in between two synchronized Generators, Droop Setting role ?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
What is safety of Ht panel
