Interested to Buy Any Domain ? << Click Here >> for more details...
Please explain about FAT? What is the difference between
FAT and SAT?
- 6 Answers
- 33046 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / shankar
Thanks freinds,
Is FAT & SAT is applicable to individual instruments.
| Is This Answer Correct ? | 1 Yes | 4 No |
Post New Answer View All Answers
What is the use of temperature compensation?
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
what is performance test.need defination
I have completed B.E. Instrumentation & control in 2009. i have 3 year industrial job experience in chemical plant.now, I want to join M.E. in external. so, Plese say easiet way and good institute name.
What are the application of bernoulli’s theorem?
need instrumentation job completed 1 year trainee ship in mnc pesticide company. now in search of job
What is motion balance principle?
can u briefly explain aboutan aryton shunt multirange DC ammeter?
How to calibrate H2s Dectector
How a conductivity sensor & analyzer work at boiler, whats the principle & science is beyond this,How conductivity sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in conductivity analyzer
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
How d.p. Transmitter can be applied to open tank?
what is the difference between attemperator and desuperheater ?
How to check vortex flow meter is in good condition while we do not having calibration setup?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
