How can we calculate earth mat conductor size ..? & give
the formula to determine earth conductor size?
- 3 Answers
- 13183 Views
- I also Faced
- E-Mail Answers
Answer Posted / zan
Several variable factors are involved in the
design of earthing mat conductor.Therefore, earthing mat
for each substation has to designed individually usually.
The earthing mat has to be designed for the site conditions
to have a low overall impedance and a current carrying
capacity consistent with the fault current magnitude. The
parameter listed below influence the design of earthing mat:
• Magnitude of fault current;
• Duration of fault;
• Soil resistivity .
• Resistivity of surface material;
• Shock duration;
• Material of earthing mat conductor and
• Earthing mat geometry.
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
what is the difference between rectifier and converter and commudator?
What is the two pole structure?
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
What happens if we run alternator on under frequency?
what will happens if one phase is missing for 33/11kv power transfomer and why?
what is dry and wet frequency withstand voltage? why & where it is used??
What is the use of bundle conductors?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
If the Brush of DC motor is shifted by 90 deg, then what happens to voltage and torque? Both voltage and torque are zero. how to justify the answer?
why moisture formation found in XLPE Armoured cable outer sheath
Define peak time.
ht side line to earth voltage
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
What is the automatic voltage regulator with servomotor?
What are Contactors? How they works and what its highest rating?
