Answer Posted / farhan
A generator set is the combination of and engine to create
power and
an alternator to change that power into electricity.
The engine turns a shaft that in turn is connected to the
alternator
This turning of the alternator creates the electrical power.
As there are different types of power all over the world,
different generator sets are built to create different
forms of electrical power.
DG Sets are the Sources which provides power NOT CONSUMING
the power,so KVA determines how much amount of power could
be genertaed from a specific DG Set in short how much the
DG set is capable of creating Amperes at certain voltage
level
For Motors....they are the power consuming devices act as a
resistive/condutive/indudtive load where reactive power is
playing part.....
| Is This Answer Correct ? | 27 Yes | 10 No |
Post New Answer View All Answers
Difference between control junction box (cjb) and power junction box(pjb)?
hey guys i scored 910 on GRE and 67 on TOEFL respectively.I have an aggregate of about 74%in my B tech.For which colleges should i apply for an MS program in electrical engineering.I am looking for colleges in NJ,SC,NC,GEORGIA, NY. Please reply with a good response.....
what is the use of sdf?
1. Why is the speed of shunt motor practically constant? 2. Why dc series motor use to start with heavy loads? 3. advantages & disadvantages of separately excited generator over self excited generator?
in indoor type circuit breakers why only the corner breaker trips specially during cold season. What is the reason.
What current flows in the transformer primary when its secondary is open?
what is the illumination level required for child play area?
What is referred to the electron in the outer orbit?
what is the meaning of 0.5ohm Resistance
How can we choose the rating of submersible motors
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
how works inductive &capacitive sensors?
Why to keep capacitor bank off while generator running.
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
