what is the use of starter in tube light?and what it
contains
- 12 Answers
- 46370 Views
- L&T, RRB, I also Faced
- E-Mail Answers
Answer Posted / gunjan
Tube light requires two things to function . Very high
starting voltage , and high voltage to continue the
operation . The starter is a circuit which breaks at
regular intervals . When you break a circuit and start
again , high voltage spark takes place . This voltage is
further amplified through the choke which is a
transformer . Thus at the beginning the starter gives high
voltage sparks . Due to this the current begins to flow
through the tube and the tube begins to glow. Once the tube
starts , the required voltage to sustain is quite low ,
which is provided by the choke .
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
What is q factor?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
What are the main faults of DC generators?
How can i get my certificate of competency as an electrical supervisor? I have complicated my B.Tech from Uttarakhand technical university this year (2012).
what are the steps involved in generator load test?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
Is there any guideline say about display of earthing value near to earth pit
What is Bolted fault?
what is meant by star/delta voltages as 440/220 in a 3 phase induction motor, and why it should be connected on STAR IN 3 PHASE SUPPLY
Why i receive the GCU fault in my DG Sychronization panel . what all the factors considered for this fault .
how to calculate fuse rating for a motor
Can anyone please give me the parameters , formula needed to calculate the circuit breakers for building services.Thanks
