Interested to Buy Any Domain ? << Click Here >> for more details...
what is use of substation? Any book on how to instal or
construction of substations?
- 6 Answers
- 14006 Views
- Siemens, I also Faced
- E-Mail Answers
Answer Posted / stalinborn
substation is used to change voltage level whether it is
step up or step down using transformer.The secondary of
transformer will feed to many feeders.for measurement and
protection of devices in substation there will be CT and PT.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
what is plunger and what's the use of it in motor alignment?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
What is the test block protection relay if any body know plz explained
sourse is 66 KV / 350 MVA, transfarmer is 1000 KVA 6.6 / 0.415 kv, iF fault is 28.75 MVA on 0.415 KV Bus then calculat the Transfarmer Impidance
What is grid collapse? what is the reason for it?
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
what is the relative size of single and three phase?
What is MS-EXCELL?
What is meant by load angle of an alternator? Upon what factors does the load angle depend?
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
The size and construction of bushings in a transformer depend upon?
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
We have a distribution transformer of 750KVA/11kv/440v and an AVR (Servo Stabilizer) of 750KVA on the LT side of distribution transformer. Also we have an ACB of 1200A on the output of distribution transformer (that is on the input of AVR). We want to have an MCCB on the output of AVR. What should be the rating?
What is the difference between AC and DC injection methods for rotor earth fault protection
