3 Core x 35 Sqmm Cable (How we measure 35Sqmm)
- 4 Answers
- 61391 Views
- Alpha Star, Brother, I also Faced
- E-Mail Answers
Answer Posted / p.h.godavary
In my answer (Answer #2), I have used the Phi symbol in the 'Area Formula'. But I find the same is appearing scrambled.
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
What is stepper motor?
Can i use the B-curve MCB instead of C-curve MCB
How to design harmonic filter at the project stage without nowing the harmonics levels
What is class ab operation?
how to calculate the conductor size for certain KV transmission line and distribution line?
What is an 86-P or an 86-A trip
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
What is the tests required for a 132 kV, 400 kV , 765 kV for a Circuit Breaker and Power Transformer before commissioning ?
What is a single phase autotransformer?
in control scheme dc logic wiring commonly using negative loop,what is the reason?if we use positive looping what will happen?
iam using DM 3251 voltmeter(1 percent accuracy)for 11KV system PT ratio is 11KV/110V.can anybody explain what is the max and min voltage deviation.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
What is Annunciation?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
