what is the reasson after complition of suction stroke and
started compression stroke inlet valve open for few digrees
Answer Posted / karthick
the reason behind that is some unburnt gas will be left in
the cylinder.so while compressing the fresh charge pushes
the unburnt gas from the cylinder for a short period
Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
Explain working of Kaplan turbine?
What is the unit of viscosity?
Distinguish between the shear center and elastic center.
What is dtsi? Why it is used in motor bikes?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
Specific strength of materials is very high when they are in fibre size but lower when they are in bar form why ?
What is function (in details) room sensor and tube or coil sensor in HVAC system?
What is the remedy if due exchanging, valve broke out during engine running operation?
What is the use of pneumatic system?
What causes diesel engine to automatically stop?
Is OHNS steel is equivalent to O1 tool steel? Suppliers give OHNS material for AISI O1 STEEL telling that both are equivalent materials. Is this correct?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
What are the causes of dirty lubricating oil?
Greetings This question is about hydraulics and I request an expert to answer it. A simple hydraulic machine is made up of two heads, a larger one with a larger force inside a wider pipe and a smaller one with a smaller force inside a smaller pipe in width as in the second picture on this link: http://science.howstuffworks.com/hydraulic1.htm The question is this: what happens if the smaller head and the smaller force doesn’t exist but the smaller pipe is high enough to take all the liquid? For example the larger head is 1.00 sqr metre and can go down 1.00m under a weight of 100.00kg. The cross sectional area of the smaller pipe is 0.001 sqr metre. Now when the larger head goes down 1.00m, how high the liquid from the wider pipe can go into the smaller pipe of the cross sectional area of 0.001 sqr metre? Regards
Study the attached ACS 790 AHU and boiler GUI and refer to the video on the software usage, catalog and the step by step document (page 9) to perform the following task: List in a table form the controllers and all their connected I/O for the boiler and the AHU.