what is the difference between electrical & electronics
Answer Posted / amrendra
electronic is a device in which or it is basically low
power device.
electrical device needs more power with respest to
electronincs device.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
How to calculat the ratio of HT\LT in energy meter
I have motor of 3 H.P. How i found the rating of capacitor use in it in single phase motor..???
how the inner and outer body is separated in aircrafts?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
Why power factor should not be in leading (capacitive) mode of any load.
Explain about technical and non technical losses in distribution system?
main difference between ac and dc?
why we use circuit breakers for switching instead of normal switching device?
what does vector group Dyn11 tell us? also tell me how will u differentiate between phase lead and phase lag thru this vector group
Zone of protection and tripping scheme of arc protection relay.
If one lamp connects between two phases it will glow or not?
WHAT KIND OF LIGHTENING PROTECTION SCHEMS CAN BE ADOPTED FOR THE FLAT ROOF OF BIG DIMENSION.