Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between power transformer &
distribution transformer and what are their ratings
respectively?
- 4 Answers
- 8261 Views
- I also Faced
- E-Mail Answers
Answer Posted / navdeep singh
power t/f is used in h.v lines or mean to say that step up
or down the high voltage .and it is used at the power
plant ,gen station , substation, its rating is 11k/132
kv ,11kv /220
distribution t/f is used in l.v lines or means to say that
it can step up and down low voltage .it is planted at near
to the load its rating is 11kv/440v
| Is This Answer Correct ? | 6 Yes | 4 No |
Post New Answer View All Answers
why should the primary of transformer be connected in delta in a heat run test?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
control & auxilary circuits used for circuir breakers
What is Harmonics how it is produced and what is the method to control the same
how ct burden,magnetising current,ratio and knee point voltage are related & derived
define the active power?
i applied for c licence with my one year apperents trainee and i have attaced with A grade contractor company experiance that is for 14 monts experiance this document is sufeicant for c licence? pls tell why they rejected
how copper and aluminium wires or cables are choose for current rating? please provide copper and aluminium wire selection chart for different current rating ?
What is vaccum currcuit breaker.define with cause and where be use it device?
If a rotary UPS is in line through grid power; What would be the impact on Power Factor if the load through rotary ups is 25% , 50% , 75% & 100%. Will the power factor reduce with less load?
A jet of fluid strikes a plate What was the force required to counter it?
How I calculate the ELCB for circuit breakers?
Please tell me in DETAIL about the following 3 types of fuses or recommend me a good power system protection book or a website link ? 1.Dropout Fuse 2.Striker Fuse 3.Empulsive fuse (not sure if its impulsive or explosion fuse , sorry)
what is the significance of terminal voltage and phase sequence in the operation of paralleling of two generators?
we specify current in case of feeder but in case of distributor voltage, why?
