Interested to Buy Any Domain ? << Click Here >> for more details...
What is the Difference Between MCCB & ACB & VCB
Answer Posted / navneet kumar
MCCB"Moulded Case Circuit Breaker" is based on expension of
bimetalic strip due to thermoelectric effect.
In ACB "Air circuit breaker" two contact seperate by the
force of spring in air.
In VCB "Vaccum Circuit Breaker" two contact seperate by
force of spring in Vaccum.
However, The application of all MCCB, ACB and VCB are same
i.e. to isolate the faulty circuit from healthy one.
| Is This Answer Correct ? | 12 Yes | 0 No |
Post New Answer View All Answers
Do closed loops systems require manual input?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
Dear sir, How to calculate 3.5 core pvc aluminium armoured cable meter wise carrying amps rating.Please give the solution with a good example.
which is the best institute for PLC,SCADA,DCS in hyderabad
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
What is time invariant system?
How many gap between finger contact in a.c.b. and v.cb.?
Draw the line diagram of diffretial relay connected to transformer?
What are the advantages of instrument transformer?
Explain difference between stand by earth fault and residual earth fault protection?
What is the significance of integral controller and derivative controller in a pid controller?
Why do we need interlocking in a HT metering or Ring main unit switchgear?
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
State Maximum Power Transfer theorem.
How to set the relay,,??
