Interested to Buy Any Domain ? << Click Here >> for more details...
1) what is the use of pin and plate vibrators during slab
casting? 2) how much cement bags are required for 1sqm
4inch brick wall? 3) Is it viable to provide overlap at
column , beam & slab junction. if no why? 4) if bar dia is
changing in column reinforcement , which dia bars overlap
is considered? 5) what is isolated and ecentric footing?
- 4 Answers
- 19279 Views
- I also Faced
- E-Mail Answers
Answer Posted / kartik khanna
vertically no. of bricks used of dimensins 19*9*9cm along
with a key mortar dimension of 10mm with each brisk is 10
slly horizontally the no of bricks used will be 10
length of cement used will be 10cm vertically and 8cm
horizontally
so area of cement used is 80 cm^2
1m^2=28.8 bags of cement
.8 *10^-2 m^2=.2304 bags of cement
but if we take mortar of 1:3 ratio instead of cement then
the cement used will be .2304\3=.0768bags of cement
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
calculate the quantity of cement ,sand,bars and aggregate used for 28*4 ft with 4 inch (125mm) thick
20 mpa what is the quantity of cement sand and aggregate in one cubic meter of pcc non rainforcement concreate kindly answer including formaula thanks
Explain the benefits of using standard terminology in the measurement process?(Tendering and estimation)
When column of building is abutting the boundary line,then suitable footing advised is
How many Sft of Level Plaster per Kg
How much 1 cum of M15, M20 & M25 concrete weigh?
Howmuch bend to be provide for 200/600 BEEM
What is Grid floor and mention its advantages ?
Define current ucs?
what is meant by residual strain?
what is anchorage length,lap length and (dont remember the last one)
What is 1/8 on the architect ruler denotes?
what is density of 20mm coarse aggregate.plz send answer my below adress e.mail
In a beam,stirrups are placed closely at ends than at centre due to shear.similarly where would ties be closer to each other-at center or at ends in a column and slab.
Explain how you can use different dimension tools in CAD? What are the different dimensions available?
