An alternator is started without excitation then how much
voltage it will produced at strating at full rpm??
- 4 Answers
- 5469 Views
- I also Faced
- E-Mail Answers
Answer Posted / alpesh
dear sir, thanks for answer.. and this 4.5 percentage
voltage is due to residual magnetism in rotor of alternator.
right??
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
HI....HOW CAN BE MESARED THE VALVE OF NEUTRAL GROUND RESISTOR WHIC IS LOCATED AT SWICHGEAR ON GENERATOR SIDE....
What are the symptoms of a bad PG card of a drive (inverter) esp. of Yaskawa Ac Drives (inverters) G7 ?
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
hi, in the event earth grounding is not available in a project, is there any other way to make the elcb work? fyi, i have an instant water heater (6.5kw) installed, however if there is grounding in the heating element inside the heater assembly, i will get grounded. thank you in advance to those who will answer my question.
Please clarify, 1. Is it required to lay two runs of GI wire along with Armoured LT cable if it is laid between one big mains (63Amps TPN SDF) to small main (32A TPN SDF) with proper glanding termination? 2. If the armoured cable with proper glanding is laid from DB to CNC machine, is it required to run two runs of body earthing to the Machine from DB? 3.If the armoured cable with proper glanding is laid from Substation to Hangar, distance is approx. 100 mtrs, is it required to do earthing at shop area though the primary termination at substation is earthed through gland.
what is tri state logic gate
How can we calculate the efficiency of a Running (On-Load) Motor ? What parameters are required and what is the method ?
write down the formula of cable size in RM if current is 50Amp.
how we decide scurt (disc) of insulator with respect to kv rating
what is negative and zero impedance in 3 phase induction motor ??
how we decide the require size is this for a known current at fuu load?
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
Write the analogous electrical elements in force voltage analogy for the elements of mechanical translational system.
What are the two major types of control system?
why do we need to use 3c+3e cable, normally i select only 3c+e cable and i think it is enough. pls explain the usefull of 3e cable ( in this project the earthing system is well done)
