Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / srinu
Normally we wlli use this BUSDUCTS in LV side of the
transformer BcoZ the Current flowing in the LV side is more
than the HV side.
If we use cable we need Large Sq .mm for which cost is more
than to replace a cable. so, it is used. and another thing
is it has high mechanical strength.
| Is This Answer Correct ? | 23 Yes | 4 No |
Post New Answer View All Answers
what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that
How we calculate the size of ht cable for any transformer
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
When we need up only in o/p 440v, so why we use directly in 11kva in input?
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
Define maximum demand?
Is Transol transformer oil comparable to nynas nytro libra?
importance of reactive power management
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
If I have 3 essential main switch board and 3 incoming electricity ,but only 1 genset running is that possible.
HOW can i REuse the fused MLL LAMPS & GLS LAMPS at our factory
