Interested to Buy Any Domain ? << Click Here >> for more details...
Can the field winding in synchronous machines be placed on
stator?What is the limitation of such arrangement?
- 2 Answers
- 5188 Views
- I also Faced
- E-Mail Answers
Answer Posted / iamdon
Generally the field winding is placed on rotor but it can
be placed on stator, without loss of generality however
such arrangement has limiataions.
Rotating armature type synchronous machines:
DC Field winding is placed on stator where as AC armature
winding is placed on rotor.The electrical input(in case of
motor)and output(in case of alternator)is supplied to or
taken from rotating armature respectively by means of
brush.The brush cann't be employed satisfactorly for large
ratings.So this arrangement is lmited for small rated
machines only.
Rotating field type synchronous machines:
DC Field winding is placed on rotor where as AC armature
winding is placed on stator.The electrical input(in case of
motor)and output(in case of alternator)is supplied to or
taken from stationary armature respectively.This
arrangement is suitable for large rating because it is
relatively easier to design insulation for stationary
armatrure as compared to rotating armature.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
An automatic water heater is an example of which type of control system?
State norton’s theorem?
How does a digital electronic meter work??????
What is the loss of transformer of 220kv/11kv, 63/80 MVA and 18.05% impedance
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
what is the difference between ac motor and dc generator
Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.
why core is useful for a transformer ?and also in its operation ?
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
Atwhat condition reverse power relay will act?
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
how calculate gd2 of ht motors
Is it possible to download the Siemens Selection Chart(TYPE 2 coordination) for 1) fuseless selection 2)Fuse selection
In MEP Services what are parts of STP and what are there function?
