Interested to Buy Any Domain ? << Click Here >> for more details...
I have carried out wiring for lighting in a shed in
Industrial area which contains Metal halide lamps & have
balanced in 3ph.Now when we put all the lines on in the
daytime the current taken at 3phases at MCB comes to be
equal i.e.28,29,28Amps respectively but in the night time
i.e between 7p.m.to 11p.m. at the same MCb the current is
52,59,62Amp, though I have fit 63A MCB it is tripping in
the above period.What may be the reason.?
Note: This industry is located in industrial area where
majority of steel ingot manufacturing plants are there.
Whether this may be due to harmonic? what should I do to
overcome above problem.pl suggest urgently.
- 4 Answers
- 6445 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankurjha
May be some other load is coming in line at night time. see
for unautherized taps in line..
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
What is the difference between grid and off- grid system??
What is open delta Xformer? It's adavntages & Use?
What do you mean by per capita requirement of electrical energy in india
.php|
Vaccum circuit breaker
What is the limitation of kirchoffs law?
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
Why cables and busbar both needed in LT Panels?
Show the schematic arrangement of diesel power station layout and give its principle of operation.
What is the function of a neutral reactor.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
How to control motor gearbox speed and friquency? If length of cable and dia given, how to measure the voltage drop?
how to carried out tan delta test in 11 KV alternator ?
