Interested to Buy Any Domain ? << Click Here >> for more details...
If Two Generators are working parellel in a network and
suddenly the field of one Generator get weakened What will
happened if there is no reverse power relay fixed in that
Generator panel????
- 7 Answers
- 10732 Views
- I also Faced
- E-Mail Answers
Answer Posted / m.k.k
field weakened generator will run as induction motor
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
234 MVA Generator 3 phase Short circuit current Values required? Gen set Rating-234 MVA, Gen Voltage-18kv, PF;0.8, Xdv:23.5 %, Transformer Rating-18/380KV, 680MVA,Yndd1 two winding, Step up TR, ZT:35.50 %,X/R 4.33 Gen CB Position, CB open ,Disconnected open, Generator Running Voltage 18 Kv, Bi mistakes generator side earth switch Closed during that time short circuit current level in 3 Phase required, and how to test on site 234MVA Generator Short circuit current,
How much voltage we need to apply in 33kv cable during hipot test of cable
we have require a Motor (1500kW, 6.6kV, 50Hz) which shall operate at 1500rpm during 30min and after it shall run on 500rpm during 15min. The same cycle shall be repetitive during the whole working days. Which method is best and economic to achieve such type of task. VFD, VVFD, Pole changing motor etc.
why we are using Load factor?
state the working principle of incondenscent tube?
What is the maximum and minimum rating of UPS?
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
how to select automotive wire by mathematical equation with given current, vlotage and resistance
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?
What is the effect of positive feedback on stability of the system?
How you give clearance to a spare feeder.
what is the standard values(Megger test) of resistances between L&N,L&E and N&E for a system on IEE regulations?
apti mainly on logical reasoning, verbal and non-verbal ability (70 percent) and remaining technical. I was in ee but technical had mech ques like on turbines and welding.
What is the slip speed?
