What is the Frequency while we step up the voltage from
220V to 11KV? Is it possible? Explain it?
Answer Posted / fransis
Generally Frequency is maintained by generation station for
a common distribution system.It is not possible to change
frequency while step up or step down the voltage on any
transformer.
This is also possible to change the frequency by term of
electronic controll device like in soft starter. In the soft
starter frequency is controlled with voltage to control the
speed of motor.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
what does a string of resistors in a series will do?
Earth leakage relay basic knowledge principle
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
Why reactors use before incoming of ac vvfd drive?
how to calculate the change over time for star delta starter for different KW motor?
WHAT IS DEAD END IN PROTECTION?
although ckt breakers have taken the place of old fuse. But instead of it , these older ones are still used in the industries and homes ? why .... what are their advantages and disadvantages ? which one is leading and winning the race and competition ?
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
Haw to check conductivity of budbar
why dimmerstate always connected in star connection? what will happen if it connected in delta?
why swityard is necessrry requirement in any bis power distributin systems?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
which type of amplifiers are used in multimete?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?