Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajasekhar
am takin a synchronous generator
in general a syn. gen operates on prinicipal of synchronism
which obtains when we excite it with any other source ...if
directly excitation is lost there wil not be any alternating
flux which plays a main role with out no operation takes place
| Is This Answer Correct ? | 3 Yes | 3 No |
Post New Answer View All Answers
I HAVE A 50A MCCB AS PER DESIGN LINE WIRE CONNECT UPWORD SIDE AND LOAD IS CONNECTED TO DOWNWARD SIDE TO THE MCCB.IF NOW ANY ONE CHANGE SUPPLY & LOAD(WISEVERSA) WHAT HAPPENS ? DOES MCCB OPERATION OR WORKING FUNCTION NORMAL IF YES THAN WHY THERE ARE MARKED LINE & LOAD ON MCCB.
In general bus riser follows the bus section in SWGR. What are impacts if bus section follows bus riser?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
how to revers the direction of single phase motor
is the value of inductance depends upon the evalue of thitha in doubly excited machine?
What type of a DC motor would you use for a lift?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
how to measure earth resistance of a substation
In Indian Household, generally we receive 220V AC single phase supply. But AC has 2 phases, +ve & -ve. So in +ve half cycle current is flowing...so what happens in the -ve half cycle?? Please illustrate.
In both 600/1000 V cable and 450/750 V cable, we can supply 415 V. However for distribution, all utilities are using only 600/100 V instead of 450/750 V. What is the reason?
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
What is the function of capacitor in electrical circuits?
What happen when change order of CT in GIS feeder?
How u can give the overload setting to any motor protection relay for a HT motors with formula and Example?
