Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / shiv
when there is no excitation ther will be no magnetic field
setup as a result of which no EMF will be induced which
means there is no output available from the generator.
| Is This Answer Correct ? | 17 Yes | 4 No |
Post New Answer View All Answers
What are the disadvantages of autotransformer?
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
How much costly in percentage wise is sandwich busduct costly than air insulated busduct of any rating?
How to calculate KVA/VA rating of PT or CT from primary & secondary voltage or primary & secondary current?
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
- two pumps must work with them at the same time but if the first pump start the second pump must delayed for some time to start also , with motor rated power = 90 KW and rated voltage = 380 V and rated power factor = 0.85 lag please draw the power and control circuit for it and determine all circuit components parameters that you use it
Why the field rheostat is adjusted such that the voltmeter reads 380V
What is the use of Surge Capacitor in LAVT?
What is the lifetime of a Thyristor? Is there a recommended lifetime for thyristors after which they should be replaced?
What is minimum permicible value of leackage current for LT Panle when applying voltage up to 3 KV for 5 Minuits?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
How to calculate mf when meter equipment and meter are connected
There are Two questions about Steam Turbine Generator... What is HRSG bypass of LP, HP used for in power generation? In particualar, in the event that fault of HP bypass, there would be STG TRIP in operation but none on the LP bypass fault...what's the reason ?
Hi.. I am a BE GRaduate in E&E. I have 8.5 Experience in Tendering & Estimation field. I have done SAP SD course few years back. But due to some reason i failed to get job in that field and continued my own field. Now I am thinking of changing into SAP seriously. How should i go ahead???
