Answer Posted / priyank sompura
distilation , drying ,absorption etc.................... are
unit operation
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
What is the significance of the minimum flow required by a pump?
X is a solid having a white colour at room temperature. It has a density about 2g/cc. Although it has melting point near 325 degree Celsius, its properties start degrading above 260 degree Celsius. The coefficient of friction is very low about 0.1. It has very good dielectric properties especially at higher radio frequencies. It has a very high bulk resistivity. It is chemically inert. It is also resistant to van der Waals force. It is hydrophobic as well as lipophobic. Creep or ‘Cold Flow’ has been observed in X.
The job profile as a Service Engineer?
What are some good strategies for curing tube vibration in shell and tube exchangers?
How can separation of chiral chemicals affect the chemical and/or pharmaceutical industries?
Hi, This is Naveen, plz if anybody have experience of IOCL interview, send me question.
Explain how can you estimate the efficiency of a pump?
Explain how do you design a vapor-liquid separator or a flash drum?
Explain the method adopted to minimize shell side pressure drop in a shell?
What are the factors involved in designing kettle type reboiler?
how does refractive index detector work?
How to caliculate the boil up rate, dia and height in both packed and tray distillation columns and any referance books for the design.
Explain some common piping materials used to transport slurries?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
What is a common failure mechanism for above ground atmospheric storage tanks?
