Answer Posted / vijay

T/C output is voltage . the voltage is dipance on the diff
detween the temperature of hot junction and cold function.
so the t/c junction is same temperature means it ll not
show the mv. you heat the hot jun then measur the mv inthe
output terminal and comare with standard chard before taht
check the terminal continty. then check the resistance of
the terminal if it is more the t/c is failure

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

2450

---

Difference between dcs and plc including date processing and architecture.

1205

---

How to regulate the flow of Air in 4" line, with max flow of 330 nm3/hr and Pressure of 0.5 bar? please suggest the type of instrument required.

1557

---

what are the steps I have to deal with?

2303

---

what is the minimum power (P=VI)to produce a spark?

2040

---

what is the protection system in solar turbine compressor

2247

---

what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail

2369

---

what will the sending unit in the fuel gauge utilizes?

1972

---

can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.

2322

---

Which topics are covered in Process Control?

2215

---

How we connect a instrument with ground, Give brief explanation with help of diagram?

2144

---

What is loop1 and loop2 in MTS LT?

3902

---

How to find out the current of two motors having same power consumption but different RPM?

2065

---

a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error

2328

---

What are the uses of orifice plates?

1144

---