Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the megger values for motor, cables and
transformers?
- 2 Answers
- 30810 Views
- ITC Infotech, I also Faced
- E-Mail Answers
Answer Posted / priyan
see sundar
Meggering test is done for any electrical equipments to
find the insulation resistance value.
As per the standards for testing the machines 3 methods are
there
1)spot reading 2)time-resistance testing method 3)step
voltage test
the following is the second mehtod it is in use nowadays
PI=10 min/1 min value
Then the Polarisation index is 2 which is consdierd
good.When it is below 1.5 you can heat the tranformer or
motor then the value will come up.
| Is This Answer Correct ? | 15 Yes | 4 No |
Post New Answer View All Answers
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
Whether amorphous core transformer is available in India?.If available then up to what rating of voltage and KVA?.
explain wiring system
what is feeder bay?
what is the function of statics switch in ups and tell me parts
what are the application of over current relay?
what is strip power factor?
what is the purpose of slope in the differential relay?why we are using two slope?but in busbar differential we are using only one slope.why?
What is the end effect of linear induction motor ??
What is domestic transformer? Draw the connection of domestic transformer.
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
What is turn ratio of a transformer?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
hi all i like to know vat is power plot in control systems also i want to know abt latest trends in electrical & electronics
