why we do 2 types of earthing on tranformer ie:body earthing
& nutral earthing , what is function.
i am going to instal a 5oo kva tranformer & 380 kva DG set
what should the earthing value
Answer Posted / sarav
Ans 3 is mostly correct. But the value of the earthing is
below 2 Ohms.
Is This Answer Correct ? | 19 Yes | 2 No |
Post New Answer View All Answers
we have two motors 1250kW,6.6kV to be coupled on the same shaft ,so please provide assistance for their synchronisation.
how the characterstics of control valve being done
How will you utilise electrical power? You can start from the generating station.
what are the parameters plays a major role in Potential transformer Burden calculation??
what is the mechanical safety of DG ?
What is the significance of integral controller and derivative controller in a pid controller?
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
why impedance relay is used for medium transmission line protection
Draw a SLD of HT distribution EB grid up to users Transformer?
can i able to get bhel previous exam question paper?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
what is level 2 automation?
Please give me a erda placement paper
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain