Design and explain a circuit to produce an unregulated full
wave D.C supply.
Answer Posted / mahavir jagdev
WHEATSTONE BRIDGE RECTIFIER CIRCUIT IS THE EASIEST.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is the working principle of servo motor? And explain it.
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
i am in need of AC SYNCHRONUS MOTOR 30KW. ANY ONE KNOWS THE MANUFACTURER OF SAME. ALSO MOSFET AC CONVERTER 20KVA CONT.OUTPUT.
Why the efficiency of generator is more than motor in swinburne's test
Dear all, I'm manikandan I have done by DIPLOMA EEE from 2011 , I have 5 years of experience from Power plant instrumentation field , which one field is give long life & which one field is best ,I confused a lot and also I'm studying AMIE, can I choose which department from Section B examination? pls tell me
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Is better to supply the voltage for static exciter from the auxiliary power source or from the SG terminals? And why?
What will be the current if the resistance total in a series circuit doubles?
What is the meaning of loop in transformer
What type of a DC motor would you use for a lift?
WHAT IS VCB SAFETY
how much LT load can bear by the 100 KW HT connection.
Can XLPE/SWB/PVC (P3) 7C X 2.5mm2 be replaced by Can XLPE/SWB/PVC (P2) 7C X 2.5mm2??? P3 vs P2