Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / be1
KVA=S , so you should know that S=Rt.(R^2+Q^2)
S=P*pf ---- (pf means power factor)
S=U*I*pf but in 3 phases you have
S=Rt.3*U*I*pf
| Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
I NEED RRB SYLABUS FOR JE ELECTRICAL ,PLEASE SEND TO MY E- MAIL ID joo28_eee@yahoo.co.in
WHERE NEUTRAL WIRE IS CONNECTED AT DOMESTIC TO TRANSMISSION LINE(SINGLE PHASE TO THREE PHASE)
What is the difference between single core 2 wire and single core 3 wire system? Which application we are using this? and for What purpose we are using this?
Which is the largest hydropower station in the world?
give me applications of sequence bridges . (used in 3 phase un balanced systems)
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
Dg pf .71 i am improve pf 0.80 what capacitor connected in dg how?
what is d check in dg 1500kva
What is the difference between Delta & Wye windings?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
how to calculate cable size in diffrent loads?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
can we start slipring motor on star delta like we start induction motor ? if yes where will we connect ?
In ht capacitor ckt we are using LBS Panel it having isolator with fuse, one of HT fuse flash over, so what is reason behind this event.
