How the Transformer oil testing is done & Why oil dielectric
goes LOW & what is solution for that ??
- 3 Answers
- 11612 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / ravikumar.g
The transformer Oil testing to be done in filtration unit
by checking the Oil Testing Kit in KV
20 KV low
when the voltage are not balancing properly and the taps
are changing regurly the oil becomes carbonsied this
carbonsied oil is acts as conductor.
So these problem so we change the Oil.
The salution for this changing the oil the transformer has
to be oilfilteration in once in a year.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
if any body have question paper of railway (section engineering),then plz send me .i will thank of him/her.
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?
WTA used cb?
how indusrial diesel generator work
Is it possible to connect a safety device in to parallel?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
what is the voltages using in movie theaters??? why ??why not other??
pls someone send me sample question papers along with the key.thanks in advance
what is the difference between 4pole & 6pole DC Motors & give advantage ?
why genarator genarating voltage 11 KV?
What is a dominant pole?
For a spring controlled governer the relation F = ar+b (F is the controlling force, r is the radius of rotation a and b are constants), indicates that the governer is
Earth bits close or open. Which is correct
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
