What's the part of OTCC in transformer?
- 7 Answers
- 20607 Views
- Bhel, RRB, I also Faced
- E-Mail Answers
Answer Posted / sudhakar ghait
OLTC - ON Load Tap Changer. When primary voltage low/high
in that condiction we will maintain our secondary voltage
by using our transformer's OLTC
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
Where servomechanism is used?
what are the values of VRY,VYB,VBR,Vry,Vyb,Vbr,Vrn,Vyn,Vbn for Magenetic balance test of 100 KVA and 63 KVA Distribution transformer
what are problems caused by the pdu in rack server
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
i am venkat i got gre 930(verbal 270 quanta 660) and my toefl score 105..here question is why u got less score in gre ? what i supposed to tell...any chance of rejection is there...my accadamics record is very good
ratings of lightning arrester
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
Can any body tell gulf interview question for experienced electrical engineer ?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
how slip power recovery system work
What does the a,b,c of 95a,95b,95c relays denotes?
To make a basic instrumentation amplifier, it takes A One op-amp with a certain feedback arrangement B Two op-amp and seven resistors C Three op-amps and seven capacitors D Three op-amps and seven resistors
Differentiate between ideal and non-ideal voltage sources?
salam&hi, i need to know about how can i calculate an enough current for the new building before i submit it to the suppliers
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
