Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rama raju
Ovality is one of the error we observe while measuring
circularity of a shaft or bore.In ovality we can measure
diffrence in dimension measured in one palne.think of egg
as an example.
| Is This Answer Correct ? | 21 Yes | 14 No |
Post New Answer View All Answers
1draw a convergent uniform and divergent circular pipe and draw hydraulic gradient line and total energy line.
what are the main challenges with solar energy system?
What is the sensitive part of the liner
Draw a parallel circuit with one battery and two resistors. Derive the formula for resistance?
Explain how do motion detectors work?
I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.
Fire Engine should be stopped in auto mode or not. If stopped then why and if not then why not?
Metals, in general are of low strength and do not possess required physio-chemical and technological properties for a definite purpose. Alloys are therefore more than metals alone. Discuss the arrangement of atoms and structures of alloys.
What is net refrigerating effect of the refrigerant?
Where can you find the feed check valve and feed stop valve and give the purpose of it?
What will you do in case of scavenging fire
Whether superheated steam can be treated like ideal gas ?
What are the causes if one cylinder in a diesel engine has a high temperature?
How cavitation can be eliminated in a pump?
which purpose use in air intake system
