Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ravikumar.g
The cosine of the angle between line voltage and line
current is known as Power Factor.
The power factor calculating the Formula =
PF = RealPower/Apparant Power
PF = KW/KVA
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
What are the types of the glands and difference between single and double compression type of cable Glands.
what are all types of cross section in AC cables?
Control wiring of a dol starter for forward and backward
how to calculate micom relay earth falt time and current sertting
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
when qty of cable being purchased is not sufficient according to the standard,what should the inspector do to ensure its quality according to the standard?
What happened if C.T mount at any cable or Bus bar in wrong direction . C.T going on proper work or not . C,T direction is essential thing to properly work.
what is class of SPD and dittels of all class ?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
Difference between ac parallel circuit and ac series circuit?
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
Can anyone tell me some hints about what type of questions are asked by the interviewer by an Electronics engineer when company is installing an IPP and wants a team of engineers?
