Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / himanshu
beacause total loop resistence is 250ohms.
so 24VDC supplied loop 1v corresponds to 4mA
and 5v corresponds to 20mA.
HART PC communicates to 1-5VDC only.
As explained in above answer 4mA is LIVE ZERo.
for 20mA reason is above 20mA current can be hazareous for
fieled.(fire).like HC and Refineries
thats why 20mA signal is used.
| Is This Answer Correct ? | 9 Yes | 4 No |
Post New Answer View All Answers
What is difference of fanuc alpha series 16i and 18i controller.also what is differnce betn TC and MC controller
What is PDS and PDMS ?
How to calibrate an pressure gauge with yantrika test bench?
Where are oxygen analysers installed in cfbc boilers? What are their usual readings?
what is function of sensor, and how is it work , explain with difination
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Whatis the reset ofset and control system in instrumentation
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
What are the materials available to prepare individually for competetive exams in Instrumentation field? Plz reply...
Explain about safety integrated level protection? . How it was differ from other protections ?
what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
What is the procedure of calibration of Load cell?
what is wave length were using ?
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
