Interested to Buy Any Domain ? << Click Here >> for more details...
What happens if a three phase induction motor is suddenly
single-phased while running? Which type of winding
connection will be affected?
- 22 Answers
- 71968 Views
- B4S Solutions, DRDO, FACT, SL Electricals, I also Faced
- E-Mail Answers
Answer Posted / rajesh shah
If a three phase induction motor is suddenly single-phased
while running, no distinct change will happen if it is
running under noload condition. You will just hear a
hunting sound and the the motor will continue to run with a
slightly lowered speed and increased current, but if the
motor is running under loaded condition it will stop down
and take excessive current due to single phasing and the
protection circuit will trip, if protection ckt is not
installed the motor will be ultimately burnt due to
excessive locked rotor current.
And note: This experiment is tested.
| Is This Answer Correct ? | 55 Yes | 2 No |
Post New Answer View All Answers
whati s the sludge current in ups
how slip power recovery system work
HOW TO REDUCE POWER PLANT AUXILIARY POWER CONSUMPTION?
why u r living from presentaly working.
Why do not we prefer non conventional sources of energy to conventional sources?
How to Preparation of online test
What is the formula to calculate a three phase alternator
Wind mill
Actuality I have at home electrical panel with 220v 50hz, and I want to converter from there to 110v 60hz, to wiring on the half of my house. Also I like to keep another half of my house with the original 220v 50hz. What is the best and safety way to do?
DG SET BLOCK DIGRAM
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
how many current required for hypo test
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
