Interested to Buy Any Domain ? << Click Here >> for more details...
What happens if a three phase induction motor is suddenly
single-phased while running? Which type of winding
connection will be affected?
- 22 Answers
- 71353 Views
- B4S Solutions, DRDO, FACT, SL Electricals, I also Faced
- E-Mail Answers
Answer Posted / rahul
If protection is proper then it will operate and stops the
motor. If there is no protection which is the normal case
in LT motors, then winding will burn there are two diffrent
pattern which will apear depending on the type of winding
connection i.e. delta or star.
You will find most of the winding failure in LT motors
happens due to single phasing.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
What is the basic of DTH.
what is the formula of starting current of 3phase and 1 phase motor???
what are inherent currents?
what is the total power generation in india?
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
what is the difference between elcb and rccb ?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
What is domestic transformer? Draw the connection of domestic transformer.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
How to calculate MCB Breaking capacity.
Whether the vacuum contactor requires Short circuit protection?If No,why?
following are the questions asked in interviews: 1) Considering the short circuit fault, which switchgear is preferable, SFU OR MCCB? Which operates faster? whicg one is popular in Indian Market and why? 2)Define SCPD. What is type2 coodination? 3)Why the contactor rating is higher for the fuseless selection than for fuse selection? whether the ratinf of SFU or MCCB remains the same in both the cases? 4)If the HP rating is known then can you calculate the ratings of L.V Switchgear(SFU/MCCB, contactor, OLR) without using the selection chart?
why the arc welding machines require parallel earthing systems? ie why each machines are connected to earth pit by separate wires during earthing? wats it adavantages?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
State the frequency for rc phase shift oscillator?
